Aaeon PC-3200 User Manual page 30

F a n l e s s P a n e l P C s
3. Place the HDD on the metal plate, and tighten the screws.
4. The HDD cable (1 x 44-pin to 1 x 44-pin) is next to the metal plate.
Connect the HDD cable to the HDD. Another end of the HDD cable is
connected to the PC board (CN21). Make sure that the red/blue wire
corresponds to Pin 1 on the connector, which is labeled on the board. Plug
the other end of the cable into the IDE hard drive, with Pin 1 on the cable
corresponding to Pin 1 on the hard drive.
Note: To avoid the IDE cable being discounted by the CD-ROM cable,
please arrange the CD-ROM cable first before connect the IDE cable.
PC-3200 Series User Manual V1.2
P C - 3 2 0 0
30