Installing System Software - Aaeon PC-3200 User Manual

F a n l e s s P a n e l P C s
Whenever you turn on the power, the system reads the settings stored in CMOS
RAM and compares them to the equipment check conducted during the power on
self-test (POST). If an error occurs, an error message will be displayed on screen,
and you will be prompted to run the setup program.
If you want to change the setup of BIOS, refer to Chapter 9 for more detailed
information.

Installing System Software

Recent releases of operating systems from major vendors include setup programs,
which load automatically and guide you through hard disk preparation and
operating system installation. The guidelines below will help you determine the
steps necessary to install your operating system on the panel PC hard drive.
Note: Some distributors and system integrators may have already
pre-installed system software prior to shipment of your panel PC.
Installing software requires an installed HDD. Software can be loaded in the
PC-3200 using any of four methods:
Method 1: Use the Ethernet
You can use the Ethernet port to download software to the HDD.
Method 2: Use the COM or parallel port
You can use Lap Link 6 or similar transmission software. Connect another PC to
the PC-3200 with an appropriate cable and transmit the software to the PC-3200.
PC-3200 Series User Manual V1.2
P C - 3 2 0 0
24