Preparation In 50 Hz Mode; Composite Video Output Adjustment (50 Hz Mode) - Sony PDW-HD1500 Maintenance Manual

8-4-4. Preparation in 50 Hz Mode

n
Perform the adjustments in the 50 Hz mode after complet-
ing the adjustments in the 59.94 Hz mode without fail.
1. Re-set the SUB-ITEM setting of the ITEM-713 in the
setup extended menu to the customer settings. (Refer
to Section 8-4-2.)
2. Switch the setting of setup menu to the 50 Hz mode
with the setup menu ITEM-013. (Refer to the Opera-
tion Manual.)
Setup menu
ITEM-013
(SYSTEM FREQUENCY SELECT)
3. Set the analog composite monitor to the PAL mode.
8-4-5. Composite Video Output Adjustment
(50 Hz Mode)
n
For the composite video output adjustment in the 59.94 Hz
mode, refer to Section 8-4-3.
Tools/Fixtures
. Analog composite waveform monitor: Tektronix 1751A,
or equivalent .
. Analog composite video monitor
n
Use this monitor for menu displaying.
Be sure to connect it to VIDEO OUTPUT COMPOSITE
2 (SUPER) connector and set it to the PAL mode.
. 75 Z terminator
8-8
Mode
8 50 Hz
Preparation
1. Connect the analog composite waveform
monitor
Connect the analog composite waveform monitor to
VIDEO OUTPUT COMPOSITE 1 connector shown as
Connection 1 in the figure "Connections". (Refer to
Connection 1 in the figure "Connections".)
. Connection 1
PDW
1
VIDEO OUTPUT
COMPOSITE
2
. Connection 2
PDW
VIDEO OUTPUT
COMPOSITE 2
Connection diagram
2. Adjustment conditions to be kept from the
previous adjustment are;
. Settings for adjustment. (Refer to Section 8-4-2.)
. Warming up of equipment to be used (30 minutes or
more).
Composite
waveform monitor
75 Z
Video monitor
(terminated with 75 Z)
Composite
waveform monitor
Video monitor
(terminated with 75 Z)
PDW-HD1500/V1 (E)