Servo2 Automatic Adjustment; Clearing Media Log; After Adjustment - Sony PDW-HD1500 Maintenance Manual

7-4. Servo2 Automatic Adjustment

n
This adjustment is not available when the loader assembly
is removed. Be sure to install the loader assembly before
making this adjustment.
1. Clean the loader assembly. (Refer to Section 5-2-2.)
2. Install the loader assembly. (Refer to Section 6-3.)
3. Display the adjustment item referring to Section 7-1-3.
4. Select "SERVO_2" with the [(]/[)] button, and press
the [*] button.
5. Select "OP-0" or "OP-1" with the [(]/[)] button, and
press the [*] button.
6. A confirmation screen appears waiting for entry of the
[SET] button.
SERVO_2
OP-0
ADJUST START?
OK: SET KEY
EXIT: MENU KEY
7. Press the [PUSH|SET] knob.
A confirmation screen appears.
SERVO_2
OP-0
INSERT ALIGNMENT DISC
PFD23A-RS.
EXIT: MENU KEY
8. Set the alignment disc.
The result appears.
SERVO_2
OP-0
ADJUSTING...COMPLETED
EXIT: MENU KEY
9. "COMPLETED" appears on the screen, and the
ADJUST screen appears.
10. If necessary, adjust the other OP in the same way.
11. Press the [&] button to display the drive maintenance
menu.
12. Clear the media log. (Refer to Section 7-5.)
7-6

7-5. Clearing Media Log

n
This menu is used to clear acquired media log.
Once this menu is executed, the cleared log data can no
longer be restored.
1. Select "OTHERS" with the [(]/[)] button, and press
the [*] button.
2. Select "CLEAR MEDIA LOG" with the [(]/[)]
button, and press the [*] button.
3. A confirmation screen appears waiting for entry of the
[SET] button.
CLEAR MEDIA LOG
ARE YOU SURE?
OK: SET KEY
EXIT: MENU KEY
4. Press the [PUSH|SET] knob.
The result appears.
CLEAR MEDIA LOG
EXECUTING...COMPLETED
EXIT: MENU KEY
5. Perform the procedure after adjustment.
(Refer to Section 7-6.)
If failed:
The following message is displayed on the screen.
The EEPROM (IC4/SE-850 board) may be defective.
CLEAR MEDIA LOG
EXECUTING...FAILED
EXIT: MENU KEY

7-6. After Adjustment

1. Turn off the power.
2. Attach the top panel. (Refer to Section 1-4-1.)
PDW-HD1500/V1 (E)