Sony PDW-HD1500 Maintenance Manual page 132

11. Press the [*] button.
The result on the tangential OUT side appears.
12. If the adjustment failed, turn the tangential OUT
adjustment screw.
m
. The adjustment screw should be turned clockwise
for this adjustment. If they are turned too much, turn
them back sufficiently, and turn them clockwise
again.
. If measured data is +, turn the adjustment screw
clockwise.
. If measured data is _, turn the adjustment screw
counterclockwise.
13. Press the [PUSH|SET] knob.
The result on the tangential OUT side appears.
14. Repeat steps 10 to 11 until satisfactory result is
obtained.
15. When the result is satisfactory, press the [*] button.
TAN ADJUST
OP-0
OUTSIDE ADJUST
MEASURE TAGET
+0.007 DEG: NG
NEXT: -> KEY
AGAIN: SET KEY
EXIT: MENU KEY
Tangential OUT adjustment screw (OP-0)
Tangential OUT adjustment screw (OP-1)
7-4
16. The result on the tangential IN side appears.
17. If the adjustment failed, turn the tangential IN adjust-
ment screw.
m
. The adjustment screw should be turned clockwise
for this adjustment. If they are turned too much, turn
them back sufficiently, and turn them clockwise
again.
. If measured data is +, turn the adjustment screw
counterclockwise.
. If measured data is _, turn the adjustment screw
clockwise.
18. Press the [PUSH|SET] knob.
The result on the tangential IN side appears.
19. Repeat steps 15 to 16 until satisfactory result is
obtained.
20. When the result is satisfactory, press the [*] button.
TAN ADJUST
OP-0
INSIDE ADJUST
MEASURE TAGET
-0.009 DEG: NG
NEXT:
AGAIN: SET KEY
EXIT: MENU KEY
Tangential IN adjustment screw (OP-0)
Tangential IN adjustment screw (OP-1)
KEY
PDW-HD1500/V1 (E)