Table of Contents
Advertisement
Chapter 4
Table 4-2. Floppy Drive BIOS Settings
# of Floppy Drive(s)
None
(1) Non-USB Floppy*
(1) USB Floppy
(2) Floppy drives
(1 USB Floppy and 1
non-USB Floppy drive*)
Table Note: *A standard 34-pin floppy cable has a twist in the cable wiring between the Floppy A
and B connectors, where Floppy B has the straight through cable (non-twist) and is the middle
connector. Due to the ReadyBoard 800's internal configuration and the cable supplied, there is only
one physical connector available (the Floppy B connector, because the Floppy A connector is not
available).
NOTE
Ampro does not recommend connecting a USB boot device to the
ReadyBoard 800 through an external hub. Instead, connect the USB
boot device directly to the ReadyBoard 800.
Any USB (block) device that emulates a hard disk drive can be used
when [USB HDD] is set as the drive option. This includes various
storage media types, such as USB hard disk drives, USB CD-ROMs,
CompactFlash™ cards, and Flash or Thumb drives. Refer also to
Boot Order settings, USB Boot Support under Advanced features,
and USB (device enable) under On-Board Controllers for USB Drive
boot order, USB Boot Enable, and the number of USB ports enabled,
respectively.
♦
Drive E – [none], [HDD on Pri Master], [CDROM on Pri Master], [HDD on Pri Slave],
[CDROM on Pri Slave], [HDD/CF on Sec Master], [CDROM on Sec Master],
[HDD/CF on Sec Slave], [CDROM on Sec Slave], [USB HDD], or [USB CDROM]
♦
Drive F – [none], [HDD on Pri Master], [CDROM on Pri Master], [HDD on Pri Slave],
[CDROM on Pri Slave], [HDD/CF on Sec Master], [CDROM on Sec Master],
[HDD/CF on Sec Slave], [CDROM on Sec Slave], [USB HDD], or [USB CDROM]
♦
Drive G – [none], [HDD on Pri Master], [CDROM on Pri Master], [HDD on Pri Slave],
[CDROM on Pri Slave], [HDD/CF on Sec Master], [CDROM on Sec Master],
[HDD/CF on Sec Slave], [CDROM on Sec Slave], [USB HDD], or [USB CDROM]
• Boot Order
st
♦
Boot 1
– [none], [Drive A], [Drive B], [Drive C], [Drive D], [CDROM], [Alarm], or [Reboot]
nd
♦
Boot 2
– [none], [Drive A], [Drive B], [Drive C], [Drive D], [CDROM], [Alarm], or [Reboot]
NOTE
The [Alarm] option sounds beeps on the PC speaker and can be
listed, like [Reboot], as the last boot device to indicate no bootable
device was found.
Any of the drives can be listed as a boot drive.
ReadyBoard 800
BIOS Settings
• Set Drives A and B to [None]
• Configure Drive A to floppy drive type (For example, [1.44MB, 3.5"] )
• Set Drive B to [None]
• Set USB Boot Support to [Enable]
• Set Drive A to [USB Floppy]
• Set Drive B to [None]
• Set USB Boot Support to [Enable]
• Configure one drive (Drive A or B) to floppy drive type
(For example, [1.44MB, 3.5"] )
• Set one drive (Drive B or A) to [USB Floppy]
Reference Manual
BIOS Setup Utility
61
Advertisement
Table of Contents
