Jumper Definitions; Led Definitions; Table 2-5. Jumper Settings; Table 2-6. Ethernet Port 1 (J16) Led Indicators - Ampro ReadyBoar 800 Reference Manual

Chapter 2

Jumper Definitions

Table 2-5 describes the jumpers shown in Figure 2-7. Refer to the Oops! Jumper to reset the BIOS.

Table 2-5. Jumper Settings

Jumper #
JP1 – ISA IRQ (SerialIRQ)
JP2 – CMOS Normal/Clear
JP3 – CF Master/Slave
JP4 – LCD Voltage Type
JP5 – COM3 RS485
JP5 – COM4 RS485
NOTE ⊗
The ISA IRQ jumper (JP1) enables the ISA interrupts when using the
MiniModule ISA board by putting the Serial IRQ signals on pin 31
(B1) of J3 on the PCI-104 connector. For full PCI-104 compatibility
the jumper should be removed (default setting). See Appendix C.

LED Definitions

Tables 2-6 and 2-7 provide the LED colors and definitions for the Ethernet ports, Port 1 (J16) and Port 2
(J17) located on the ReadyBoard 800. Refer to Figures 2-5 and 2-9.

Table 2-6. Ethernet Port 1 (J16) LED Indicators

Indicator
Ethernet
Link/Activity
LED
Ethernet
Speed LED

Table 2-7. Ethernet Port 2 (J17) LED Indicators

Indicator
Ethernet
Link/Activity
LED
Ethernet
Speed LED
ReadyBoard 800
Installed/Enabled
Enabled (pins 1-2) See Note ⊗
Normal (pins 1-2) Default
Master (pins 1-2) Default
Enable +3.3V (pins 1-2)
Termination (pins 1-2)
Termination (pins 3-4)
Definition
Link/Activity LED – This yellow LED is the activity/link indicator
and provides the status of Ethernet port 1 (J16).
• A steady On LED indicates a link is established
• A flashing LED indicates active data transfers
Speed LED – This green LED is the Speed indictor and indicates
transmit or receive speed of Ethernet port 1 (J16).
• A steady Off LED indicates the port is at 10BaseT speed
• A steady On LED indicates the port is at 100BaseT speed
Definition
Link/Activity LED – This yellow LED is the activity/link indicator
and provides the status of Ethernet port 2 (J17).
• A steady On LED indicates a link is established
• A flashing LED indicates active data transfers
Speed LED – This green LED is the Speed indictor and indicates
transmit or receive speed of Ethernet port 2 (J17).
• A steady Off LED indicates the port is at 10 or 100BaseT speed
• A steady On LED indicates the port is at 1000BaseT speed
Reference Manual
Product Overview
Removed/Enabled
Disabled (removed) Default
Clears Date and Time only (pins 2-3)
Slave (removed)
Enable +5V (pins 2-3) Default
No Termination (removed) Default
No Termination (removed) Default
15