Ampro ReadyBoar 800 Reference Manual page 71

Chapter 4
However, connecting a Hot Cable to the other port (port not selected) overrides this field
setting and activates the connected port. Connecting a Hot Cable to one of the serial ports
only allows console redirection when a Hot Cable is actually connected to Serial 1 or 2.
Use the modified serial cable described in Chapter 3, under Hot (Serial) Cable.
♦
USB Boot Support – [Disabled] or [Enabled]
This field allows you to select any USB device as a boot device. Refer also to Drive
Assignment settings, Boot Order settings, and USB (device enable) under On-Board
Controllers for the USB Drive settings and the number of USB ports enabled, respectively.
•
If this field is set to [Disabled], none of the USB devices connected to the ReadyBoard
800 can be used as a boot device.
•
If this field is set to [Enabled], any of the bootable USB devices connected to the
ReadyBoard 800 can be used as a boot device.
NOTE Ampro does not recommend connecting a USB boot device to the
ReadyBoard 800 through an external hub. Instead, connect the USB
boot device directly to the ReadyBoard 800.
♦
LAN Boot – [None], [LAN 1], or [LAN 2]
This field allows you to boot the system over one of the Ethernet connections (LAN). Refer
to LAN Boot in Chapter 3, Hardware and Appendix C, PXE Agent BIOS Settings for more
information.
•
If this field is set to [LAN 1], the ReadyBoard 800 will boot from Ethernet 1 (J16). If you
enable LAN Boot for [LAN 1], you will need to reboot the system and go to PXE agent
BIOS settings. Refer to Appendix C, for more information.
•
If this field is set to [LAN 2], the ReadyBoard 800 will boot from Ethernet 2 (J17). If you
enable LAN Boot for [LAN 2], you will need to reboot the system and go to PXE agent
BIOS settings. Refer to Appendix C, for more information.
• On-Board Serial Ports
NOTE
Serial Ports 1 and 2 can not share the same IRQs, and the IRQs used
for Serial Ports 1 and 2 can not be used for Serial Ports 3 and 4 and
vice versa.
♦
Serial 1 – [Disabled], [3F8h], [2F8h], [3E8h], [2E8h], [260h], [2F0h], [3E0h], [2E0h],
[200h], or [220h]
This field specifies the base address used for Serial Port 1.
•
IRQ – [none], [1], [3], [4], [5], [6], [7], [9], [10], [11], [12], [14], or [15]
This field specifies the IRQ used for Serial Port 1. If this field is set to [none], then no
IRQ is assigned, making it available for other devices.
♦
Serial 2 – [Disabled], [3F8h], [2F8h], [3E8h], [2E8h], [220h], [228h], [238h], or [338h]
This field specifies the base address used for Serial Port 2.
•
IRQ – [none], [1], [3], [4], [5], [6], [7], [9], [10], [11], [12], [14], or [15]
This field specifies the IRQ used for Serial Port 2. If this field is set to [none], then no
IRQ is assigned, making it available for other devices.
ReadyBoard 800 Reference Manual
BIOS Setup Utility
65