Table of Contents
Advertisement
Chapter 1
21) Install the desired
Operating System (OS)
on the hard disk drive.
NOTE
The CoreModule 420 SBC ships from the factory configured only for CRT
support. Ampro provides LCD/TFT support for flat panels with specific
resolutions. Refer to the CoreModule 420 Reference Manual, the Release Notes,
and Virtual Technician on the web site for instructions and additional information
when customizing the BIOS to a particular flat panel.
Table 1-1. Jumper Settings
Jumper #
JP1 Serial Port 1
Termination
JP2 Serial Port 2
Termination
JP4 & JP5
BIOS/DOC Select
JP5
JP4
4
2
4
2
3
1
1
BIOS/DOC Select
Jumper Setting
(Shown in Default)
JP6
Flat Panel Voltage
Selection
JP7
DiskOnChip Boot
Address Select
JP8 Serial Port 1
JP9 Serial Port 2
Note: JP8 and JP9 Enable/Disable the Serial ports at the STPC Altas CPU chip.
10
• Refer to Installing Software, Drivers, and Utilities in Chapter 2
and the CoreModule 420 Doc & SW CD-ROM for more
information.
• Locate the desired Operating System (OS) diskette(s), or CD-
ROM and follow the manufacturer's instructions for installing
the OS and the necessary drivers onto the hard disk drive.
• Refer to Note on Hard Drive installation from 11b, page 7.
For Windows Operating Systems, most of the necessary drivers are
found on the manufacturer's installation CD-ROM.
For non-Windows Operating Systems, some or all of the necessary
drivers may be found on the manufacturer's diskette(s) or CD-ROM.
• Refer to Installing Software, Drivers, and Utilities in Chapter 2
and the CoreModule 420 software subdirectory on the
CoreModule 420 Doc & SW CD-ROM for instructions.
Installed
Enable RS485 Termination
(Pins 1-2)
Enable RS485 Termination
(Pins 1-2)
Enable Internal BIOS – Normal operation,
(Pins 1-3 on both JP4 & JP5)
Enable External BIOS – Used for recovery
(Pins 1-2 on both JP4 & JP5)
Enable DOC – Boot from DiskOnChip in
bytewide socket (Pins 1-3 & 2-4 on both
JP4 & JP5) Default setting
+3.3 Volts (Pins 1-2)
Access from DC000h-DDFFFh
(Pins 1-2)
Enable Serial Port 1
(Pins 1-2) Default setting
Enable Serial Port 2
(Pins 1-2) Default setting
QuickStart Guide
Setting Up the CoreModule 420
Removed
Disable RS485 Termination
(No jumper) Default setting
Disable RS485 Termination
(No jumper) Default setting
Disabled – Won't Boot
(See other positions)
Disabled – Won't Boot
(See other positions)
Disabled – Won't Boot
(See other positions)
+5 Volts (Pins 2-3)
Access from CC000h-CDFFFh
(No jumper)
Disabled Serial Port 1
(Pins 2-3)
Disabled Serial Port 2
(Pins 2-3)
CoreModule 420
Advertisement
Table of Contents
