Table of Contents
Advertisement
2. Removing the Pick-Up Drive
Assembly
1) Remove the rear cover l/2 and the rear right
cover.
2) Disconnect the four connectors 0, and
remove the three screws 0; then, remove the
pick-up motor driver PCB @ together with the
support plate.
Figure 4-202C
3)
4) Remove the pick-up assembly.
5) Remove the screw @ from the pick-up relay
CANON CLClOOOREV.lMAY1997
Loosen the two screws @I to loosen the ten-
sioner plate 0; then, detach the drive belt 0.
Figure 4-203C
PCB, and remove the two screws @ from the
pick-up drive assembly.
Figure 4-204C
Advertisement
Table of Contents
