Canon CLC1000 Service Manual page 272

n Adjusting the Image Read Start Position
must check the point of retention (FUNC
You
ATTRACT) before making the following adjust-
ments:
Before starting service mode, turn OFF the
original detection mechanism.
Select the <ADJ-XY> screen, and press the
Copy Start key.
The appropriate copying modes will be set
automatically, and a copy will be made with a
shift of about 20 mm as shown in Figure 3-
704.
If any part of the image is missing, decrease
3)
the values of 'ADJ-X' and 'ADJ-Y'.
If an area outside the image is copied,
4)
increase the values of 'ADJ-X' and 'ADJ-Y'.
ADJ-Y
CANON CLClOOO REV.1 MAY 1997 PRINTED IN JAPAN (IMPRIME AU JAPON)
A D J - X
2 0
Figure 3-1104