Disassembly; Reverse Gate - Sea-doo 2003 XP DI Shop Manual

DISASSEMBLY

GTI Series, RX DI and GTX Series

Reverse Gate

To remove reverse gate, refer to JET PUMP section.
Reverse Cable
Unscrew bolt no. 1, washers and the elastic stop
nut retaining reverse cable no. 2 on pivot arm.
1. Reverse cable
2. Pivot arm
3. Bolt
4. Washer
5. Elastic stop nut
Unscrew the cable lock no. 11 then remove the
half rings no. 12.
Remove the seat and the glove box. Refer to
HULL/BODY.
GTX Series
Push the vent tube toward the front of the vehicle
to get greater access to the interior lever and the
reverse cable support.
To release the vent tube, press down its locking
tabs and move the tube.
There are two locking tabes; one above and one
underneath the hose.
SMR2003-042_13_04A.FM
Section 13 PROPULSION SYSTEM
DO NOT REMOVE the vent tube completely.
1. Engine vent tube
2. Vent tube locking tab
3. Interior lever
4. Reverse cable support
On the interior lever no. 3, unscrew the elastic
stop nut and the washer retaining the reverse ca-
ble.
Remove the bracket no. 6.
NOTE: Before removing reverse cable from hull,
note cable routing for reinstallation.
1. Interior lever
2. Elastic stop nut and washer
3. Reverse cable
4. Bracket
www.SeaDooManuals.net
Subsection 04 (REVERSE SYSTEM)
13-04-7