Riding Plate - Sea-doo 2003 XP DI Shop Manual

Section 16 HULL/BODY
Subsection 02 (ADJUSTMENT AND REPAIR)
Torque screw number

RIDING PLATE

Removal
All Models
Remove inlet grate.
Remove jet pump. Refer to JET PUMP.
Remove the speed sensor from the riding plate (if
applicable).
Loosen riding plate screws.
NOTE: An impact screwdriver should be used to
loosen tight screws.
Using a low height hydraulic bottle jack and 2 steel
plates, pry out riding plate.
TYPICAL
1. Hydraulic bottle jack
2. Steel plates
16-02-32
to 26 N•m (19 lbf•ft). Cleaning
Scrape off all excess of sealant from riding plate
and hull.
Clean hull surface with acetone based solvent to
eliminate grease, dust and any residue of sealant.
Installation
All Models except GTX DI and GTX 4-TEC
Models
Apply Loctite The Right Stuff Gasket as indicated
by the shaded areas in the next illustrations. Fol-
low also the torquing sequence as shown in the
same illustrations.
NOTE: Apply Loctite The Right Stuff Gasket as in-
dicated by the shaded area.
GTI, GTI LE, GTI LE RFI, LRV DI XP DI AND RX DI MODELS
www.SeaDooManuals.net
SMR2003-046_16_02A.FM