Blacklist; Audio Settings; Custom Prompts - Yeastar Technology NeoGate TB400 User Manual

T.38 Support
Hotline
Two-stage Dialing
Outbound Dial Pattern
Strip
Prepend

4.3.2 Blacklist

Blacklist is used to block an incoming or outgoing call. If the number of incoming or
outgoing call is listed in the number blacklist, the caller will hear the following prompt:
"The number you have dialed is not in service. Please check the number and try
again".The system will then disconnect the call.
You can add a number with the type: inbound, outbound or both.

4.4 Audio Settings

4.4.1 Custom Prompts

Upload custom prompts on this page. You can also download it and save it as a
backup.
NeoGate TB400 User Manual
Enable or disable T.38 FAX.
Direct number to the SIP Server. The parameter is ignored
if a SIP Account is selected on this route.
Enable or Disable Two-stage Dialing.
Outbound calls that match this dial pattern will use this
outbound route.
Allows the user to specify the number of digits that will be
stripped from the front of the phone number before the call
is placed. For example, if users must press 0 before dialing
a phone number, one digit should be stripped from the dial
string before the call is placed.
These digits will be prepended to the phone number
before the call is placed. For example, if a trunk requires
10-digit dialing, but users are more comfortable with 7-digit
dialing, this field could be used to prepend a 3-digit area
code to all 7-digit phone numbers before calls are placed.
Figure 4-21 Blacklist
38/40