Blacklist; Callback Settings - Yeastar Technology TA1610 User Manual

https://arttel.ru/
Items
Call Destination
Hotline
Outbound Dial
Pattern
Strip
Prepend

Blacklist

Blacklist is used to block an incoming or outgoing call. If the number of incoming or
outgoing call is listed in the number blacklist, the caller will hear the following prompt:
"The number you have dialed is not in service. Please check the number and try
again". The system will then disconnect the call.
You can add a number with the type: inbound, outbound or both.

Callback Settings

1) If you'd like to use callback feature, please make sure it's enabled on the
IP->Port or Port->IP/Port route setting panel.
2) No callback rules needed to be set if the trunk supports call back with the caller ID
directly.
3) Add Callback numbers, then callback will work for the added callback numbers.
Tick "Allow All Numbers", callback feature will work for all numbers.
https://arttel.ru/shop/voip-shlyuzy/yeastar-neogate-ta1610
Table 5-5 Description of Handle Matched lncoming Calls Settings
Description
Choose the trunk or trunk group to route the incoming calls
to.
Direct number to the SIP Server. The parameter is ignored
if a SIP Account is selected on this route.
Outbound calls that match this dial pattern will use this
outbound route.
Allows the user to specify the number of digits that will be
stripped from the front of the phone number before the call is
placed. For example, if users must press 0 before dialing a
phone number, one digit should be stripped from the dial
string before the call is placed.
These digits will be prepended to the phone number before
the call is placed. For example, if a trunk requires 10-digit
dialing, but users are more comfortable with 7-digit dialing,
this field could be used to prepend a 3-digit area code to all
7-digit phone numbers before calls are placed.
Figure 5-5 Blacklist
TA1610 User Manual
30/62