Yeastar Technology NeoGate TB400 User Manual page 30

TLS Verify Server
TLS Verify Client
TLS Ignore Common Name
TLS Client Method
RTP Port Start
RTP Port End
DTMF Mode
MaxRegistration/
Subscription Time
Min Registration/
Subscription Time
Default Incoming/Outgoing
Registration Time
Register Attempts
Register Timeout
Calling Channel Codec
Priority
DNS SRV Look Up
User Agent
2) NAT
When using NeoGate TB400 as a TLS client, whether or not
to verify server's certificate. It is "No" by default.
When using NeoGate TB400 as a TLS server, whether or
not to verify client's certificate. It is "No" by default.
Set this parameter as "No", then common name must be the
same with IP or domain name.
When using NeoGate TB400 as TLS client, specify the
protocol for outbound TLS connections. You can select it as
tlsv1, sslv2 or sslv3.
Beginning of the RTP port range.
End of the RTP port range.
Set the default mode for sending DTMF. The default setting:
rfc2833
Maximum duration (in seconds) of a SIP registration. The
default is 3600 seconds.
Minimum duration (in seconds) of a SIP registration. The
default is 60 seconds.
Default Incoming/Outgoing Registration Time: the default
duration (in seconds) of incoming/outgoing registration.
The number of SIP REGISTER messages to send to a SIP
Registrar before giving up. The default is 0 (no limit).
Number of seconds to wait for a response from a SIP
Registrar before classifying the register has timed out. The
default is 20 seconds.
Once enabled, when dialing out via SIP/SPS trunks, the
codec of calling channel will be selected preferentially. If not,
NeoGate TB400 will follow the priorityorderin your SIP/SPS
trunks.
Please enable this option when your SIP trunk contains
more than one IP address.
To change the user agent parameter of asterisk, the default
is "NeoGate TB400"; you can change it if needed.
NeoGate TB400 User Manual
30/40