Table of Contents
Advertisement
A
175
176
177
L-____________________________
~
178
•
179
106
Replacement of turn light bulbs
Undo screws «E» securing the reflectors to the turn
signal light, push the bulb inward turning to the left,
and take it off its socket.
Note
In
reliltlng the reflectors, tighten the screws
uniformly and not excessively to prevent breakages.
d
Panel board - Speedometer -
Rev-counter (See fi9· 178)
To replace bulb «A» from speedometer ,,8», from
rev-counter "C» and the lighted indicators «0» on
panel «E» it is necessary to withdraw the speedo and
rev-counter sockets, also sockets "G" from the panel.
Replace then the burnt
out
bulbs.
•
•
•
Bulbs (12 V)
Headlight"
high and low beam 45/40 W (<<8» in fig. 174);
parking light 3 W
(~C"
in fig. 174).
Tail light:
number plate, parking and slop light 5/21 W («B»
in fig. 176).
•
•
Turn signal indicators: 21
W
(<<C» in fig. 176).
Warning lights on panel: 1,2 W («E" in fig. 178).
•
Speed a and rev-counter illumination
:
3
W
{«D» in
fig. 178}.
Horn
(~A"
in fig. 179)
Brand: "Belli" (9012/2) - current absorbtion 3 A.
Overhaul and repair of horn
If the horn has losl Its tone or has failed altogether,
ensure first that the trouble is not in any other com-
ponent the electric system.
It the horn does not emit any sound, check the effi-
ciency of the button and if all cables are properly
screwed down.
If the sound is faint, ensure its fixing bolt is tight.
If the horn sounds continuously, check the ground
contact in the connection from button to horn.
If all these controls are negative, it is obvious that the
fault lies in the horn itself and it should be entrusted
for repair to the makers or to a highly qualified
workshop.
9
Cables
Ensure all cables are in perfect slate. If scraped or
cracked anywhere, replace them.
NB
Ensure that all additional accessories are con-
nected to terminals that can stand the extra load in
order not to go beyond the terminal capacity and so
avoid damage the electric system.
Advertisement
Table of Contents
