System Configuration Switch Default Settings - HP ProLiant ML310 Maintenance And Service Manual

Connectors, Switches, and LEDs
Table 4-6: System Configuration Switch Default Settings
Position
1
2
3
4
5
6
7
8
* The server serial number must be re-entered through RBSU after clearing the NVRAM. Refer to
"Re-entering the Server Serial Number" in Chapter 2.
** Switch positions 7 and 8 are reserved for HP authorized service providers only. Do not change
the specified default setting for these positions, unless instructed otherwise.
4-10
Default Description
Off Reserved
Off Lock configuration
Off Tower/rack configuration
Off Diskette boot
Off Password disable
Off Clear CMOS and NVRAM*
Off Reserved**
Off Reserved**
HP ProLiant ML310 Server Maintenance and Service Guide
Settings
N/A
Off = Normal
operation
On = Configuration
changes cannot be
made
Off = Tower
configuration
On = Rack
configuration
Off = Observe RBSU
diskette boot selection
On = Override RBSU
setting and allow
diskette boot selection
Off = Enable
password prompts
On = Disable
password prompts
Off = Normal
On = When the server
is powered up, all
system configuration
information is erased
N/A
N/A