Loosening The Diskette Drive Screws; Replacing The Hard Drive - HP ProLiant ML310 Maintenance And Service Manual

To replace the hard drive:
1. Loosen the four diskette drive screws. They do not need to be removed.
Figure 2-15: Loosening the diskette drive screws
2. Slide the drive into the drive bay (1), and then secure it with two screws on each side of
the drive compartment (2).
3. Tighten the diskette drive screws (3).
Figure 2-16: Replacing the hard drive
4. Slide the drive compartment back into the chassis, and then replace the three shipping
screws.
5. Reconnect the diskette drive and hard drive cables, and then replace the access panel.
HP ProLiant ML310 Server Maintenance and Service Guide
3
3
2
Removal and Replacement Procedures
2
1
2-19