System Board; Removing The System Board - HP ProLiant ML310 Maintenance And Service Manual

System Board

To remove the system board:
1. Complete the preparation procedures. Refer to "Preparation Procedures" in this chapter.
2. Remove the access panel. Refer to "Access Panel" in this chapter.
3. Remove all expansion boards seated on the system board.
4. Disconnect all cables from the system board.
5. Remove the seven screws securing the system board to the chassis (1).
6. Slide the system board away from the back of the server, and then pull the system board
out of the chassis (2).
Figure 2-32: Removing the system board
To replace the system board, reverse steps 2 through 6.
IMPORTANT: The server serial number must be re-entered through RBSU after replacing the system
board. Refer to the "Re-entering the Server Serial Number" section.
HP ProLiant ML310 Server Maintenance and Service Guide
CAUTION: Electrostatic discharge (ESD) can damage electronic components. Be sure that
you are properly grounded (earthed) before beginning any installation procedure. Refer to
"Electrostatic Discharge Information" in this chapter for more information.
Removal and Replacement Procedures
2-37