Connecting To A Uninterruptible Power Supply (Ups) - NEC Express5800/R310g-E4 User Manual

Chapter 2 Preparations

When the device is not Plug and Play device, turn off the server and devices to be connected before
connecting.

Fix the power cord or interface cable with cable ties.

Make sure that no pressure is applied on the plug of power cord.

2.4.1 Connecting to a uninterruptible power supply (UPS)

To connect the power cord of the server to the uninterruptible power supply (UPS), use the connector output on
the rear of the UPS. For details, refer to the manual supplied with the UPS.
Example
Option slot
If you want to control the power of server with the output of UPS, change the following BIOS settings.
[Server] - [Power Control Configuration] - [AC-LINK]
Select Power On to perform automatic operations by using the UPS.
See the following for details.
Chapter 3 (2. BIOS Setup Utility (SETUP)).
Chapter 3 (1. System BIOS) in Maintenance Guide
62
Universal Serial Bus (USB) port
Overload protection
reset button
Input connector
Voltage sensitivity setting button
(NEMA5-15P)
Express5800/R310g-E4, R320g-E4, R320g-M4 User's Guide
Connector outputs
TVSS device connector
Computer interface port (COM)
2. Installation and Connection