Removing The Cartridge Carriage And Main Drive Belt - HP DesignJet 200 Service Manual

Removing the CWrtridge CWrriWge Wnd MWin Drive Belt
C A U T I O N
If you are installing a new cartridge carriage or
a new carriage PCA, ensure that the plotter
firmware is compatible with it.
Incompatibilities could destroy the cartridges.
(Details D chapter 9.)
1 Remove the window D page 6 15.
2 Remove the center cover D page 6 16.
3 Remove the left endcover D page 6 18.
4 Remove the right endcover D page 6 19.
5 Remove the encoder strip D page 6 39.
6 Remove the trailing cable guide D page 6 43.
7 Remove the Y tensioner and
housing D page 6 45.
9 Lift the encoder strip bracket clear of the
plotter.
6 48 Removal and Replacement
8 Remove the two screws that secure the
encoder strip bracket to the service
station housing.
Encoder-strip
bracket
10 Remove the three screws that secure the
service station cover to the
service station housing.
Cover
0D2 DmbtinJ: Do no o e
h ee c e Man ally mo e he
e ice a ion led o en
mo e f eely benea h he co e
Torx-15
Service-station
housing
Torx-15
igh en he
e ha i
C3187 90000