Removing The Drive Roller - HP DesignJet 200 Service Manual

Removing the Drive Roller

1 Remove the electronics enclosure
cover D page 6 5.
2 Remove the window D page 6 15.
3 Remove the center cover D page 6 16.
4 Remove the left endcover D page 6 18.
5 Lift the left front trim clear of the
plotter.
6 Remove the right endcover D page 6 19.
7 Remove the front panel
assembly D page 6 32.
8 Remove the carriage motor D page 6 35.
9 Remove the media motor D page 6 37.
10 Remove the encoder strip D page 6 39.
11 Remove the bail D page 6 56.
12 Remove the service station D page 6 57.
13 Remove the overdrive
roller D page 6 60.
15 Unclip the cables from the holding clip
underneath the media motor mount.
16 Lift the mount clear of the plotter.
17 Remove the screw that attaches the
media director to the chassis assembly
and remove the media director.
Media director
C3187 90000
C A U T I O N
14 Remove the three screws that attach the
media motor mount to the right sideplate.
0einst2lling: Press down on the media
mount as you replace the three screws.
This is to ensure correct spacing between
the drive roller and the cartridge nozzles.
(Details D chapter 9.)
Torx-20
Media motor mount
18 Pull the pinch arm lever forward to raise
the pinch arm assembly.
Torx-15
Pinch-arm lever
In the following step, take care
not to damage the bail sensor.
Press down here as
you tighten screws
Removal and Replacement 6 69