Removing The Overdrive Enclosure - HP DesignJet 200 Service Manual

Removing the Overdrive Enclosure

1 Remove the window D page 6 15.
2 Remove the center cover D page 6 16.
3 Remove the left endcover D page 6 18.
4 Remove the right endcover D page 6 19.
5 Remove the overdrive roller D page 6 60.
7 Remove the two indicated screws from
the right sideplate.
RIGHT HAND SIDE
6 62 Removal and Replacement
6 Remove the three indicated screws from
the left sideplate.
Torx-15
Torx-20
8 Lift the overdrive enclosure clear of the
plotter.
Torx-15
Torx-20
1
2
0D2 DmbtinJ: See following procedure
LEFT HAND SIDE
Overdrive enclosure
1
2
3
C3187 90000