Removing The Stepper Motor - HP DesignJet 200 Service Manual

Removing the Stepper Motor

1 Remove the electronics enclosure
cover ' page 6 5.
2 Remove the window ' page 6 15.
3 Remove the center cover ' page 6 16.
4 Remove the left endcover ' page 6 18.
6 Disconnect the stepper motor cable
connector from the main PCA and the
holding clip.
C3187 90000
5 Open the flexible, DANGER HIGH
VOLTAGE," insulation cover.
Carefully flex the cover to open t Do not
detach the cover from the plotter
7 Remove the bottom shoulder screw on
the cartridge adjust linkage, and lower
the lever arm below the stepper motor.
Torx-15
Stepper-motor
connector
0D2 DmbtinJ: Rest the bottom arm of the
l nkage on top of the stepper motor shaft
Removal and Replacement 6 21