Removing The Entry Platen - HP DesignJet 200 Service Manual

Removing the Entry Platen

1 Remove the window D page 6 15.
2 Remove the center cover D page 6 16.
3 Remove the left endcover D page 6 18.
4 Remove the right endcover D page 6 19.
5 Remove the overdrive roller D page 6 60.
6 Unscrew the pinch arm lever and right
front trim and lift them clear of the
entry platen, taking care not to damage
the window sensor.
7 Remove the overdrive enclosure
D page 6 62.
9 Remove the two indicated screws from
the right sideplate.
1
2
C3187 90000
8 Remove the three indicated screws from
the left sideplate.
Torx-20
Torx-15
Torx-20
10 Underneath the plotter, remove the screws
from the front of the bottom cover.
Torx-15
11 Unscrew the power switch from the left
sideplate.
Torx-20
zH H ha H c H
zH H ha H H c H
Torx-20
Removal and Replacement
1
2
3
6 65