Power Requirements; Choosing An Interface Cable (More ' User's Guide) - HP DesignJet 200 Service Manual

Power Requirements

HP C3180A and C3181A DesignJet 200 and HP C3187A and C3188A DesignJet 220 plotters
have self adjusting power supplies and do not require a voltage selector or switch settings
prior to use. The table below lists the power requirements for the plotters.
Source Voltage Requirements:
Frequency:
Consumption:
The ac power outlet (mains) must have a protective
W A R N I N G
earth (ground) terminal. Serious shock hazard leading
to death or injury may result if the plotter is not
properly grounded.
The power cord supplied with the plotter should meet the plug requirements for the
geographical area. However, different power cords (international options) are available.
(Cable part numbers ' chapter 10.)
Choosing an Interface Cable
(Instructions ' User's Guide, chapter 1, w Choosing an interface cable.)
Serial (RS 232 C) Interface
for the RS 232 C interface. A longer cable is permissible, provided the load capacitance does
not exceed 2500 picofarads.
Parallel (Bi Tronics/Centronics) Interface
for the parallel interface.
(Interface descriptions ' Service Manual, chapter 5, w Input/Output Interfaces.)
(Pin specifications ' User's Guide, chapter 6, w Interface specifications.)
(Cable part numbers ' Service Manual, chapter 10.)
2 2 Site Planning and Requirements
Power Requirements
A short cable (less than 15 meters or 50 feet) is recommended
Use a short cable (less than 2 meters or 6.6 feet)
Voltage Max current (rms)
100 V ac 1.4 A
120 V ac 1.2 A
220 V ac 650 mA
240 V ac 600 mA
47-53 Hz and 57-63 Hz
140 watts maximum
C3187 90000