HP DesignJet 200 Service Manual page 130

12 Pull the entry platen out from the plotter
in order to access the media sensor.
14 Cut the plastic tie that fastens the
media sensor cable to the underside of
the entry platen.
C A U T I O N
Take care not to cut the media sensor cable
itself.
6 66 Removal and Replacement
13 Detach the media sensor holder from
the underside of the entry platen by
pulling the holder straight out.
15 Lift the entry platen clear of the plotter.
Plastic tie
0D2 DmbtinJ: See following procedure
C3187 90000