Fan - HP ProDesk 400 G1 Maintenance And Service Manual

Fan

Description
Fan
Fan, BFR/PVC free
NOTE:
System board appearance may vary.
1. Prepare the computer for disassembly
2. Remove the access panel
3. From the outside, rear side of the chassis, remove the two Torx T15 screws that secure the fan to
the chassis.
4. From the inside of the chassis, disconnect the fan control cable (1) from the system board
connector labeled CHFAN2.
5. Lift the fan out of the chassis (2).
To install the fan, reverse the removal procedure. Be sure to orient the air flow out of the computer.
86 Chapter 5 Removal and replacement procedures: Microtower
(Preparation for disassembly on page
(Access panel on page 43).
Spare part number
745052-001
748825-001
42).