6.
Press inward on the release lever at the rear of the device (1) and slide the device out of the rear
of the drive bay (2).
Installing a 3.5-inch device
1.
Prepare the computer for disassembly
2.
Remove the access panel
3.
Remove the front bezel
a bezel blank, remove the bezel blank. See
4.
Install 6-32 guide screws in the holes on each side of the device.
NOTE:
on page 105
When replacing a device, transfer the four 6-32 guide screws from the old device to the new one.
(Access panel on page
(Front bezel on page
HP has supplied four extra 6-32 guide screws on top of the drive cage. Refer to
for an illustration of the extra guide screws location.
(Preparation for disassembly on page
93).
94). If you are installing a drive in a bay covered by
Bezel blanks on page 96
92).
for more information.
Drives
Drives
109