Installing a 3.5-inch device (model 480 and model 490)
1.
Prepare the computer for disassembly
2.
Remove the access panel
3.
Remove the front bezel
drive in a bay covered by a bezel blank, remove the bezel blank.
4.
Slide the device into the drive bay (1) and install the two 6-32 mounting screws in the side of the
device (2) to secure it in place.
NOTE:
Refer to
When replacing a device, use the two 6-32 mounting screws that were removed from the old
device to install the new one.
(Access panel on page
(Front bezel on page
HP has supplied four 6-32 mounting screws on the front of the chassis behind the bezel.
Drives on page 59
for an illustration of the extra mounting screws location.
(Preparation for disassembly on page
43).
44). Remove the front bezel. If you are installing a
42).
Drives
69