Recovering The Configuration Settings - HP ProDesk 400 G1 Maintenance And Service Manual

Table 7-5
Option ROM Launch
Policy
AMT Configuration

Recovering the Configuration Settings

This method of recovery requires that you first perform the Save to Removable Media command
with the Computer Setup (F10) Utility before Restore is needed. (See
on page 139
NOTE:
It is recommended that you save any modified computer configuration settings to a USB flash
media device and save the device for possible future use.
To restore the configuration, insert the USB flash media device with the saved configuration and
perform the Restore from Removable Media command with the Computer Setup (F10) Utility.
(See Computer Setup—File on page 139
150 Chapter 7 Computer Setup (F10) Utility
Computer Setup—Advanced (for advanced users) (continued)
Let you set the launch policy for option ROMs. An Option ROM typically consists of firmware that is
called by the system BIOS. For example, an adapter card that controls a boot device might contain
firmware that is used to connect the device to the system once the Option ROM is loaded.
PXE Option ROMs (legacy only/EFI only/do not launch)
●
Storage Option ROMs (legacy only/EFI only/do not launch)
●
Video Option ROMs (legacy only/EFI only)
●
NetClone Option ROMs (legacy only/do not launch)
●
Allows you to set:
AMT (enable/disable). Allows you to enable or disable functions of the embedded
●
Management Engine (ME) such as Active Management Technology (AMT). If set to disable, the
Management Engine is set to a temporarily disabled state and will not provide functions
beyond necessary system configuration. Default is enabled.
Unconfigure AMT/ME (enable/disable). Allows you to unconfigure any provisioned
●
management settings for AMT. The AMT settings are restored to factory defaults. This feature
should be used with caution as AMT will not be able to provide any set AMT management
functions once unconfigured. Default is disabled.
Hide Unconfigure ME Confirmation Prompt (enable/disable). Allows you to set the system to
●
not display the confirmation to unconfigure ME.
Watchdog Timer (enable/disable). Allows you to set amount of time for a operating system
●
and BIOS watchdog alert to be sent if the timers are not deactivated. BIOS watchdog is
deactivated by BIOS and would indicate that a halt occurred during execution if the alert is
sent to the management console. An operating system alert is deactivated by the operating
system image and would indicate that a hang occurred during its initialization. Default is
enabled.
in the Computer Setup—File table.)
in the Computer Setup—File table.)
Computer Setup—File