Removing A 3.5-Inch Device - HP ProDesk 400 G1 Maintenance And Service Manual

6.
Connect the power cable (1) and data cable (2) to the back of the hard drive.
NOTE:
supply to the rear of the hard drive bays.
7.
Connect the opposite end of the data cable to one of the white (model 400) or light blue (model
490) SATA connectors on the system board.
NOTE:
connections – model 480 on page 57

Removing a 3.5-inch device

CAUTION:
computer.
1.
Prepare the computer for disassembly
2.
Remove the access panel
3.
Remove the front bezel
The power cable for the hard drives is a two-headed cable that is routed from the power
Refer to System board connections – model 400 on page 56
All removable media should be taken out of a drive before removing the drive from the
(Access panel on page
(Front bezel on page
for an illustration of the system board drive connectors.
(Preparation for disassembly on page
43)
44)
or System board
42)
Drives
65