Hard Drive And Optical Drive Cables And Connectors - HP EliteOne 705 G1 Maintenance & Service Manual

Hard drive and optical drive cables and connectors

Description
Optical drive cable (data and power assembly)
Hard drive cable (data and power assembly)
The hard drive and optical drive connectors are located near the middle of the computer, partially under the
main frame. Each connector is secured with two Torx screws and has two cables that connect to the system
board.
To remove the hard drive or optical drive connector:
1. Prepare the computer for disassembly (see
2. Remove the stand (see
3. Remove the access panel (see
4. Remove the ride side panel (see
5. Remove the lower rear panel (see
6. Remove the VESA mounting plate (see
7. Remove the memory modules (see
8. Remove the processor heat sink (see
9. Remove the processor (see
10. Remove the WLAN module (see
11. Remove the system board (see
12. Remove the front bezel and display panel (see
13. Remove two Torx screws that secure the hard drive connector or the optical drive connector to the
computer.
14. Remove the cables from the metal clips built into the computer.
15. Disconnect the hard drive cables or the optical drive cables from the system board.
NOTE:
wires.
ENWW
Stand on page
Access panel on page
Side panels on page
Processor on page
WLAN module on page
System board on page
Be careful not to damage the cable when disconnecting it from the board. Do not pull on the
Preparing to disassemble the computer on page
29).
33).
76).
Lower rear panel on page
VESA mounting plate on page
Memory on page 44).
Heat sink on page 51).
53).
49).
78).
Front bezel and display panel on page
Hard drive and optical drive cables and connectors
59).
72).
27).
85).
91