Card Reader Board - HP EliteOne 705 G1 Maintenance & Service Manual

Card reader board

The card reader board is located on the right side of the system board. You must remove the system board
before you can remove the card reader board. The card reader board is secured with two screws.
To remove the card reader board:
1. Prepare the computer for disassembly (see
2. Remove the stand (see
3. Remove the access panel (see
4. Remove the ride side panel (see
5. Remove the lower rear panel (see
6. Remove the VESA mounting plate (see
7. Remove the memory modules (see
8. Remove the processor heat sink (see
9. Remove the processor (see
10. Remove the WLAN module (see
11. Remove the system board (see
12. Remove the two Phillips screws that secure the board to the system board.
13. Position the system board upright with the right side toward you.
84 Chapter 5 Removal and Replacement Procedures
Preparing to disassemble the computer on page
Stand on page 29).
Access panel on page
Side panels on page
Lower rear panel on page
VESA mounting plate on page
Memory on page
Heat sink on page
Processor on page 53).
WLAN module on page
System board on page
33).
76).
59).
72).
44).
51).
49).
78).
27).
ENWW