Recovering The Configuration Settings - HP EliteOne 705 G1 Maintenance & Service Manual

Table 6-5 Computer Setup—Advanced (for advanced users) (continued)
Update BIOS via Network
Ethernet Connection

Recovering the Configuration Settings

This method of recovery requires that you first perform the Save to Removable Media command with the
Computer Setup (F10) Utility before Restore is needed. (See
Computer Setup—File table.)
NOTE: It is recommended that you save any modified computer configuration settings to a USB flash media
device and save the device for possible future use.
To restore the configuration, insert the USB flash media device with the saved configuration and perform the
Restore from Removable Media command with the Computer Setup (F10) Utility. (See
on page 95
106 Chapter 6 Computer Setup (F10) Utility
Allows you to use F10 Setup to check for BIOS updates from hp.com and apply them using either a
manual selection or an automatically scheduled check on boot-up.
NOTE: If Windows BitLocker Drive Encryption (BDE) is enabled, HP requires that BDE be suspended
temporarily before the BIOS is flashed. You must get the BDE recovery password and PIN before
suspending BDE. After updating the BIOS, you can resume BDE.
● Update BIOS via Network (Enabled/Disabled). Enables or disables BIOS network support. Default is
enabled.
● Update Source (HP/Custom). Selects hp.com or a locally managed custom address to serve BIOS
updates. Default is HP.
Update Address. If Custom is selected for Update Source, the URL of the locally managed server.
●
Automatic BIOS Update Setting (Disabled, Check and install all updates automatically, Check and
install only important updates automatically, Check for updates but let me decide whether to install
them). Enables or disables the network BIOS update scheduler. Default is disabled.
Automatic Update Frequency (Daily, Weekly, Monthly). Sets the frequency of checks to the BIOS
update server. If a newer version of BIOS is available on the network server, the system will prompt
to update the BIOS. Default is Monthly.
Force Check on Next Reboot (Disabled/Enabled). During the next boot, checks whether an updated
BIOS is available. This value is independent of the Automatic Update Frequency setting. Default is
disabled.
Provides information about the network connection.
in the Computer Setup—File table.)
Computer Setup—File on page 95 in the
Computer Setup—File
ENWW