HP EliteOne 705 G1 Maintenance & Service Manual page 121

least four seconds then press the power button again to restart the computer. If the system will not
shut down, unplug the power cord, wait a few seconds, then plug it in again. The computer will restart if
it is set to power on automatically as soon as power is restored in Computer Setup. If it does not restart,
press the power button to start the computer.
● Reconfigure the computer after installing a non-plug and play expansion board or other option. See
Solving hardware installation problems on page 131
● Be sure that all the needed device drivers have been installed. For example, if you are using a printer,
you need a driver for that model printer.
● Remove all bootable media (CD/DVD or USB device) from the system before turning it on.
● If you have installed an operating system other than the factory-installed operating system, check to be
sure that it is supported on the system.
● If the system has multiple video sources (embedded, PCI, or PCI-Express adapters) installed (embedded
video on some models only) and a single monitor, the monitor must be plugged into the monitor
connector on the source selected as the primary VGA adapter. During boot, the other monitor
connectors are disabled and if the monitor is connected into these ports, the monitor will not function.
You can select which source will be the default VGA source in Computer Setup.
CAUTION: When the computer is plugged into an AC power source, there is always voltage applied to the
system board. You must disconnect the power cord from the power source before opening the computer to
prevent system board or component damage.
ENWW
for instructions.
Helpful hints 111