Editing Programs; Editing Phases; Navigating Between Phases - Distform MyChef 4 GN 2/3 Installation, Use And Maintenance Manual

If a probe-controlled cooking cycle is running, the time/program display will show
the actual temperature of the probe. When you press the
display will show the desired temperature of the core probe.
When a probe-controlled cooking program is running, the chamber
temperature display shows the desired temperature, and the probe
display shows the actual food temperature.
7.6

Editing programs

You can modify programs 1 to 99 by holding down the button for a few seconds
, until you hear a beep and PR appears in the program display.
Then you can change the cooking settings as the previous subsection explained.
To save the program, press the
To add or delete phases in programs 1 to 99, you must first enter program
editing mode.
7.7

Editing phases

Phase editing can be done directly in the manual program (---). If you would like
to change the phases of any user program (1 to 99), first enter program editing
mode (see 7.6).
7.7.1

Navigating between phases

To navigate between different phases, briefly press the
Figure 29: Program button and program display.
button until the program number reappears.
150
button, the probe
button.