Delta T And Core Probe Cooking - Distform MyChef 4 GN 2/3 Installation, Use And Maintenance Manual

When a probe-controlled cooking program is running, the chamber
temperature display shows the desired temperature, and the probe
display shows the actual food temperature.
7.5.4

Delta T and core probe cooking

The Delta T and probe-controlled cooking mode ends the cooking when the
temperature in the center of the food reaches the selected temperature. The
temperature differential between the cooking chamber and the food remains
constant and matches the value selected in the temperature display.
To use this mode, choose a Delta T temperature as well as a food temperature by
pushing the and
the button, the oven will begin to heat, constantly adapting the chamber
temperature, and will stop when the core probe temperature matches the set
temperature. At this point, the time display will read END until the user ends the
cooking by pressing the button briefly
Example shows cooking with Delta T at 25º until the temperature in the food's
center reaches 55º.
Figure 27: Oven temperature (dark color) and
probe temperature (clear color).
For this cooking mode, you must connect the multi-point probe or the
sous-vide probe.
If you try to start the probe-controlled program while the probe is not
connected, the oven will beep and the program will not start.
button, and adjust it with the knob. When you press
(see section 7.10).
149
Figure 28: Cooking settings.
+