Installation; Before Installation - Sanyo FXD-RR1 Operating Instructions Manual

INSTALLATION

1. BEFORE INSTALLATION

When mounting the unit in a car, keep the unit as level as possible.
If the unit must be mounted at an angle, due to the design of the vehicle, make sure the unit does not tilt by
more than 30°.
Note
The unit will not operate if it is installed incorrectly.
max. 30°
2. INSTALLATION PROCEDURES
FIRE WALL
When mounting the unit into a DIN–standard cutout (182 × 53 mm) in the dashboard or console, attach the
provided Removable Trim Ring to the unit.
Insert the mounting bracket into the DIN-standard cutout (182 × 53 mm) in the dashboard or console.
1.
2.
Bend the mounting bracket stopper outward until the bracket fits snugly in the cutout.
3.
Attaching the Mounting Strap to the underside of the dash board, using screw. Attach the back of the
unit to the Mounting Strap using support stem bolt and hardware.
Mounting Strap
DASH BOARD
Mounting
OR CONSOLE
Bracket
Removable
Trim Ring
GB–23