Installation; Unit Removal - Sanyo CDF-R800 Operating Instructions Manual

..-.
Installation
1.
2.
3.
4.
Install the supplied trim panel (Fig. 1-@)) to the unit (Fig. 1-@).
Inseti the supplied mounting bracket (Fig.1 -@ into DIN-standard Cutout 182 x
53mm in the dashboard or a console.
Bend the stoppers of the mounting bracket to the outside untill the bracket is tight-
ened in the cutout. (Fig.2)
Insert the unit into the mounting bracket untill it locks in place.
Unit removal
1. Insert the supplied removing levers
into the two holes provided on each
side of the trim panel.
2. Move the tips of levers upward, and
press them against the unit.
Make sure a distinctive clicking is
heard.
3
3. Pull the levers
to remove the unit.
24