Sanyo FXD-RR1 Operating Instructions Manual page 9

• Sub disp
You can adjust with which priority items are to be displayed in the Sub display. Display priority can be
set for the following 2 items ;
Mode
Clock
•Disp speed (Display speed)
The scroll speed of the display indication can be switched.
Fast
Slow
•Scroll type (Display type)
The scroll type of the display indication can be switched.
With pauses
Rolling
• LV Meter(Level Meter)
The sensitivity of the level meter display can be switched.
0
1
2
3
4
• LV Sens (Level sens)
The sensitivity of the level meter display can be switched.
Lo
Hi
• Contrast
The contrast of the display can be adjusted.
+3 ~ 0 ~ –3
• Illumi.
Select the illumination status when the power is off.
off
on
• Message
Turn on/off message can be switched.
on
off
• Clock adj.
Adjust the clock. (See page 5)
• Standby Time
Select the length of time until the sound will go out after opening the front panel.
min
0sec
15sec
30sec
1min
3min
10min
• Demo
The demonstration of each function is repeatedly shown on the display screen. The demonstration
starts about few seconds after power off.
on
off
: Mode indication (FM/AM/CD etc,.).
: Clock indication.
: Fast.
: Slow.
: Scrolls across the display with pause.
: Scrolls across the display.
: No meter is indicated.
: The level meter goes upward/downward.
: The level meter goes up dividing from the center segment.
: Only the very top segment light.
: The remaining segments light. (Opposite of 3)
: Normal sensitivity.
: High sensitivity.
: Only the power button will light up.
: All buttons will light up.
: A message is displayed when power on/off.
: No message is diplayed.
: Sound will not go out.
: Sound will go out immediately.
: Sound will go out after 15 seconds.
: Sound will go out after 30 seconds.
: Sound will go out after 1 minute.
: Sound will go out after 3 minute.
: Sound will go out after 10 minute.
: The demonstration is displayed after power off.
: The demonstration is not displayed after power off.
GB–8