Identifying The Cable Connectors - NCR 7455 Hardware User's Manual

Identifying the Cable Connectors

The following illustration identifies each of the cable connectors. Refer
to the sections following the illustration for specific instructions on
installing each peripheral. After installing the peripheral and LAN
cables, replace the cable cover and tighten the thumbscrew.
Note: 12VDC output on the powered RS-232 ports.
VGA LAN USB
RS-232/C
RS-232/D
Powered
Keyboard
Caution: The wedge scanner port on the POS daughterboard and the
Ethernet port on the processor board are the same type of connector.
The Ethernet cable and port are labeled with the PC99 standard
connector color (black) for Ethernet devices to reduce the risk of
plugging these devices incorrectly. If an Ethernet hub is connected to
the powered scanner port, the Ethernet hub will be permanently
damaged.
Note: The scanner port comes with a blank connector plug installed.
This plug must be removed before a device can be connected to the
scanner port.
RS-232/A RS-232/B
Powered
Power
Mouse
Mic
Scanner
Cash
Drawer
Chapter 2: Hardware Installation
Infared Speaker
Speaker
Parallel
(Customer Display)
2-5
Out
18367