Table of Contents
Advertisement
Chapter 2: Hardware Installation 2-19
Finalizing the Installation
After the hardware installation has been completed, the terminal can
be powered up to finalize the installation. The operating system, along
with platform modifications, is pre-installed. The following sections list
the steps involved to complete the system installation for each of the
Gold Disk operating systems.
Completing the OS Installation (Windows 2000)
Power on the system to complete the software installation. This
installation also installs most of the additional software and drivers
that are included in the disk image. Complete the installation as
follows.
1. After the terminal reboots, press Next at the Windows Setup screen.
2. Accept the Microsoft license agreement.
3. Enter the User Name and Organization.
4. Enter the Computer Name for the client.
5. Enter the Administrator's Account Password (optional).
6. When prompted, press Finish to reboot the client.
7. Log in when prompted.
8. If you have a touch screen equipped unit, open the Control Panel
and run the MicroTouch screen calibration.
Completing the OS Installation (Windows NT)
Power on the system to complete the software installation. This
installation also installs most of the additional software and drivers
that are included in the disk image. Complete the installation as
follows.
1. After the terminal reboots, press Next at the Windows Setup screen.
2. Accept the Microsoft license agreement.
3. Enter the User Name and Organization.
Advertisement
Table of Contents
