Table of Contents
Advertisement
2-4
Chapter 2: Hardware Installation
Routing the Cables
The 7455 contains three anchors to secure cables to the base of the unit
using a cable tie wrap. Remove the power supply cover from the base
of the unit, which is secured by two screws on the bottom rear. Use a
tie wrap to secure the Ethernet cable to one of the provided molded
cable tie holders on the base. This should provide sufficient strain relief
to prevent the cable from becoming tight and damaging the connector
on the Processor Board.
The peripheral cables are routed down through the Mount Assembly
and out the rear of the unit.
Bottom View
18366
Advertisement
Table of Contents
