Boot-Time Diagnostic Screen - NCR 7455 Hardware User's Manual

Boot-Time Diagnostic Screen

This option displays the diagnostic screen during boot.
1. Move the cursor to Boot-Time Diagnostic Screen and press Enter.
2. Select the desired setting from the drop-down menu.
Disabled
Enabled
Note: If the Boot-Time Diagnostic Screen is disabled, you will instead
see the logo of the POST results. If an error occurs, the terminal beeps
and may wait for user input before booting, but does not automatically
display an error message. You may display the Boot-Time Diagnostic
Screen by pressing ESC during boot-time. Pressing ESC also causes the
terminal to display the Boot Menu instead of automatically following
the configured boot sequence specified in Setup.
QuickBoot Mode
This option decreases boot time by skipping some tests while booting.
1. Move the cursor to QuickBoot Mode and press Enter.
2. Select the desired setting from the drop-down menu.
Disabled
Enabled
Continuous POST
This option is enables POST to repeat in a loop until canceled.
1. Move the cursor to Continuous POST and press Enter.
2. Select the desired setting from the drop-down menu.
Disabled
Enabled
Chapter 3: Setup 3-23