Table of Contents
Advertisement
3-2
Chapter 3: Setup
Entering Setup Without a Keyboard (on units with Touch-
Screen)
1. Apply power to the terminal.
2. Calibrate the touch screen.
a. When the screen prompt that says Touch the screen two times to
enter Setup appears, touch the screen three times. This causes
the system to bypass the BIOS Setup and go directly to the
Touch Screen Calibration Setup.
Note: Setup can also be entered from the Boot Menu that is
displayed when you press ESC during POST.
b. As instructed on the screen, touch the circle near the lower-left
corner of the screen. For best results, press the screen near the
circle and then slide your finger onto the circle without raising
your finger from the screen.
c. Using the same method as above, touch the circle near the
upper-right corner of the screen.
d. You should receive a Successful Calibration message and then the
PhoenixBIOS Setup Utility should come up.
e. Select the setup parameters by touching the controls at the
bottom of the screen.
Advertisement
Table of Contents
