Remove All Cable Harnesses From The Non Modular Door - NCR OPTIC 5 Installation Instructions Manual

20

Remove all cable harnesses from the non modular door

1. Identify the connections on the Customer Node to any other components on the
2. Identify the remaining connections to the Customer Node and note the connections
3. Unplug all remaining cables on the non modular door.
4. Detach the ground wires.
5. Check for any other cables or wires attached from the cabinet to the Non Modular
door. Remove and discard.
for re-installation. Unplug the now marked cables from the Customer Node. Set
inside the cabinet.
Door. Place into the cabinet. Remove and discard any loose cables no longer
connected to any components.
Deinstallation Instructions For Encore