Figure 3-2 Honeywell Ip Utility User Interface - Honeywell HD54IP User Manual

Refresh button
Disconnect button
The Discovery pane lists
the IP devices found on the
network and groups them
by device type.
Enable or disable HTTP
Server.
Use Batch Firmware Upgrade
to select a group of devices and
upgrade the firmware for all.
Document 800-09311V3 Rev A
07/2013
Performance Series Rugged Day/Night H.264 IP Dome Camera User Guide
5. Automatically discover or manually refresh the list of devices on the network.
Use the manual refresh if a new device was added after you logged onto the system.
• You do not need to do anything to discover devices. When you log on to the IP
Utility, the devices on the network — including the devices on other subnets —
are automatically discovered and listed in the Discovery pane. After the initial
discovery, the network automatically continues to discover devices that are newly
added to the network.
• To manually refresh the device list, click the Refresh (
the top of the Discovery pane.
6. Enable or disable the HTTP Server check box for additional security. Only an
Administrator can disable (uncheck the box), resulting in the user being unable to
access the web client, although video recording is unaffected.
Figure 3-2 Honeywell IP Utility User Interface
Connect button
Limited/No connectivity
button
The Status bar displays how many
devices are on the network, which
one you are connected to, and
which user is logged on.
Use the Product Filter drop-down
menu to select a specific device,
such as all HD4 series cameras.
The About menu displays the
software version installed.
On the User tab, Administrators
can change the web-client user
passwords.
IP Network Setting assigns
network settings automatically
or manually.
Upgrade Firmware
downloaded from the
Honeywell web site.
Use Launch Browser
to open the HD4
series IP web client for
each device.
) button, located near
Click Apply to save
manually configured
network settings.
37