IP Camera Web Client
Configuring IP and Firmware Settings
Resetting the Device
52
Depending on the hardware installation, there is a tab called either Device Information or
Device Settings. In both cases, the IP and Firmware Settings panel mirrors the information
available in the Honeywell IP Utility. It provides read-only network settings, firmware
settings, and video formats without having to access the IP Utility.
The Device Settings are the same for the primary and secondary streams.
Figure 4-6
IP and Firmware Settings: Device Information Tab
Device Name as entered in the
IP Utility program
IP Address on the network
(DHCP/Static/APIPA)
Subnet Mask and Default Gateway
address that connects the camera to
the network
MAC Address is a factory assigned
address unique for each device
Firmware Settings including
product name and version
Video Format - NTSC or PAL
Select a location for saving
Snapshots
When resetting the device, you can choose from: Restart, Restore, and Reset to Defaults.
See
Figure
4-6. Each of these functions take approximately two minutes to complete and,
during that time, the camera will lose connection to the web client. You will be asked if you
wish to proceed before the action occurs.
Restart
Restarts the camera while maintaining the existing configurations.
Restore
Resets the camera to the factory defaults, except the network settings.
Reset to
Resets to the camera's factory defaults, including network settings.
Defaults